How to groove wood veneer ?
Slotting is one of the commonly used methods in wood veneer processing, suitable for situations where metal lines need to be added at the joints of wood veneer. Firstly, it is necessary to use a trimming machine to replace the T-shaped blade and slot along the section of the wooden veneer that needs to be slotted. Then, use a flat file to smooth out the surface of the cut. Before slotting, it is necessary to measure the required length and depth of the slot to ensure that it can be neatly and consistently displayed on the wooden surface.
How to make the recently popular curved wall with wooden veneer ?
Firstly, use plywood as a base and create the desired curved shape; Then use a slotting machine to groove the back of the wooden veneer according to the size of the curvature. The smaller the curvature, the more grooves need to be made. It should be noted that the grooves should not be too deep when slotting, and should be about 10 to 15 threads away from the surface; If the thickness of the wood veneer is less than 5mm, an industrial hot air blower can also be used to heat it behind the wood veneer. After heating, the wood veneer will become soft, and then it can be slowly bent to the desired curvature. After bending, turn off the hot air blower to cool and shape it. Pay attention to even heating during heating.
Precautions
During the construction process of wood veneer, the following points should be noted:
(1)It is necessary to maintain the flatness of the wooden veneer to avoid deformation or scratches caused by improper operation;
(2)It is necessary to regularly clean and maintain the wood veneer to maintain its smoothness;
(3)Wear gloves when slotting and bending to avoid hand injuries;
(4)Be careful to avoid scratching the surface of the wooden veneer with sharp objects.
Case Presentation
Video explanation
